Expert Plumbing Services in Bartlesville, Oklahoma

In the cold weather, water can freeze inside your pipes and cause the pipes to break. A leaking pipe can cause flooding and serious water damage in your home if it’s not fixed immediately.

If you have a burst pipe, the first step is to disable your home’s water supply. You’ll complete this at the main water shutoff valve, which is usually located in your utility area or basement. Turning the valve clockwise will disable the water.

Then contact us at 918-333-0376 right away. Whether it’s behind a partition, in your yard or under your property’s foundation, we’ll be able to locate the leaking pipe and fix it quickly.

If you aren’t using more water than usual and your payment doubles, there’s a good probability you have a water leak. Sometimes your payment will go up just a little bit. It’s harder to catch but will normally become more prominent as the leak gets larger.

It can be hard to discover a water leak without expert assistance. Nevertheless you can check your water meter to figure out if the leak is inside or outside your home.

Some mildew is normal in hot rooms like bathrooms. But it’s not normal to find big amounts growing on a non-shower wall, the ceiling or on baseboards, particularly if these areas feel pliant to the touch.

A leaky pipe can make walls, ceilings and floors to feel soft or sag. It can also leave water stains on surfaces.

These challenges can occur in rooms with poor venting or high humidity. But they’re especially hard if you are enduring other signs of a leaky pipe, like mold or musty smells.

Standing water can make a space smell musty. If the room also has wet walls or floors, you could have a water leak.

Your fittings can back up sewer water and cause damage when the water compression drops in your home. This can be caused by a broken backflow preventer, sewer line deterioration or other local issues. Contact us at 918-333-0376 at the initial sign of backflow and our team will get it fixed quickly.

A number of things can be the issue when your water pressure is low. There could be a obstruction in your plumbing fixture. It can also be caused by a faulty water heater or a busted pipe.

If you own a water heater with a tank, it has a limited capacity for hot water. If you’re getting cold water when you don’t use a lot of warm water, something could be wrong. Your boiler could be leaking, nonfunctional or need to be replaced.

A block is probably to be the reason when your sink or shower is draining too slowly. We’ll use a special instrument like a drain snake to break it up and get your fittings draining correctly again.

If your toilet’s tank seal fails, it will signal the tank to continue refilling. A toilet that keeps refilling can suddenly drive up your water dues.

Your water should be transparent.

Don’t have concern if it comes out off-color once in a while, as this generally just means there’s air in the water reserve. If you discover particles settling in your glass, you should have your water heater checked.

Water that’s any other color can be dangerous to your health. Listed are a few circumstances that may cause your water to be discolored:

• Brown, red or yellow—This is typically caused by a water main break in your location. It could also mean your pipes are old or rusty.
• Green or blue—This is very serious, since it means your pipes are likely corroded. Your water can taste brassy or bitter on account of a high concentration of copper or lead. Long-term consumption has been connected to serious health issues in adults and children, including intestinal illnesses, cancer and seizures.

If you’re seeing discolored water or sediment in your water, connect with us at 918-333-0376 and we’ll determine the issue.

If your toilet’s tank seal is broken, it will signal the tank to continue refilling. A toilet that is always refilling can rapidly drive up your water bills.